2024-12-10

Front Door Trim Pad - Beltline Assembly - LH (Remove and Install)

Correction code 1513047071 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-12-10: Added caution to not release the trim with too much force.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Release the clips (x18) that attach the LH front lower beltline assembly to the vehicle, disconnect the electrical connectors (x2), and then remove the assembly from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not release the trim from the door assembly with too much force. Release the trim gently to disconnect the electrical connectors.

Install

  1. Position the LH front lower beltline assembly to the vehicle, connect the electrical connectors (x2), and then secure the clips (x18) that attach the assembly to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  2. Raise the LH front window and close the LH front door.