2024-07-23
Screw Cover - 1st Row Seat - LH (Remove and Install)
Correction code
1307060071
1307060072
1307060111
1307060112
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Remove the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
- Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Install).
- Lift the outer edge of the LH outboard riser bolt cover, and then pull the cover away from the riser to remove it.
Install
- Install the LH outboard riser bolt cover.
- Install the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Install).
- Install the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
- Raise the LH front window and close the LH front door.