23/07/2024 17:26:24
Cabin HVAC - Hepa Filter (Remove and Install)
Correction code
1810021061
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-04-25: Added link for HEPA filter cover.
- 2024-04-10: Reorganized steps for additional information. Added remove and install videos.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Remove the frunk access panel. See Front Luggage Storage Compartment - Frunk Access Panel (Remove and Install).
- Remove the HEPA filter cover. See Cabin HVAC - HEPA Filter Cover (Remove and Install).
-
Use the pull tabs on the HEPA filter
to remove it from the vehicle.
NoteNote the air flow direction for installation.
Install
-
Install the HEPA filter into the
vehicle.
NoteMake sure the filter is in the correct orientation.
- Install the HEPA filter cover. See Cabin HVAC - HEPA Filter Cover (Remove and Install).
- Install the frunk access panel. See Front Luggage Storage Compartment - Frunk Access Panel (Remove and Install).