2024-07-23

Harness - FEM (Remove and Install)

Correction code 1710051031 1710051032 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. On the touchscreen, touch Controls > Suspension > Very High to set the vehicle ride height to Very High.
  3. Put the vehicle in Service Mode. See Service Mode.
  4. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  5. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  6. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  7. Remove the front fascia assembly. See Front Fascia (Remove and Install).
  8. Release the connector locks and disconnect the FEM harness electrical connectors (x3), release the harness clips (x4), and then pass the harness through the opening in the front end module to remove it from the vehicle.

Install

  1. Position FEM harness into the vehicle, connect the FEM harness electrical connectors (x3) and engage the connector locks, and secure the harness clips (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Pass the harness through the opening in the front end module.
  2. Install the front fascia assembly. See Front Fascia (Remove and Install).
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  6. Exit Service Mode. See Service Mode.
  7. On the touchscreen, touch Controls > Suspension > Standard to set the vehicle ride height to Standard.
  8. Raise the LH front window and close the LH front door.