23/07/2024 17:28:04

Electromechanical Brake Booster - Remote Reservoir Tube (Remove and Install)

Correction code 3320033032 3320033031 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  2. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  3. Remove the brake remote reservoir. See Electromechanical Brake Booster - Brake Remote Reservoir (Remove and Install).
  4. With assistance, remove the bolts (x3) that attach the A/C compressor to the Megabeam, and then carefully rest the A/C compressor on the HCU module bracket.
    5 Nm (3.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Support the AC compressor while removing the fasteners.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid straining the MV or HV harnesses.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Press the yellow tab on the remote reservoir tube to release it, and then remove the tube from the vehicle.

Install

  1. Position the remote reservoir tube into the vehicle, and then connect the tube to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to ensure the tube is fully engaged.
  2. With assistance, position the AC compressor to the Megabeam, and then install the bolts (x3) that attach compressor to the Megabeam.
    5 Nm (3.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Support the AC compressor while installing the fasteners.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Avoid straining the MV or HV harnesses.
    Informational PurposesAn informational icon, calling your attention
    Note
    Start the fasteners by hand.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the brake remote reservoir. See Electromechanical Brake Booster - Brake Remote Reservoir (Remove and Install).
  4. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  5. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).