2026-08-09

Airbag - Front Passenger (Remove and Install)

Correction code 2001038021 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-02-19: Added note on using PROC_RCM_DISARM if using this procedure to diagnose the SRS.
Warning
If using this procedure to diagnosis the vehicle's Supplemental Restraint Systems (SRS), disarm the RCM, which will prevent all airbags and pretensioners from deploying. Re-arm the RCM after all of the vehicle's SRS components are re-installed.
  • Disarm RCM:PROC_RCM_DISARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Disarm RCM
    • Safety & Restraints ➜ Seats ➜ Disarm RCM
    via Toolbox:(link)
  • Re-arm RCM:PROC_RCM_ARMvia Service Mode Plus:
    • Safety & Restraints ➜ Airbags ➜ Re-Arm RCM
    • Safety & Restraints ➜ Seats ➜ Re-Arm RCM
    via Toolbox:(link)

Remove

  1. Remove the RH air wave duct. See Panel Duct - RH (Remove and Install).
  2. Disconnect the connectors (x3), remove the bolts (x6) that attach the front passenger airbag to the vehicle, and then remove the airbag from the vehicle.
    8 Nm (5.9 lbs-ft)
    Note
    Pull back the white tabs simultaneously to release the connectors.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the front passenger airbag into the vehicle, install the bolts (x6) that attach the airbag to the vehicle, and then connect the connectors (x3).
    8 Nm (5.9 lbs-ft)
    CAUTION
    Install the bolts with dimpled heads in the vehicle's rearmost positions.
    Note
    Make sure the connectors are fully seated.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the RH air wave duct. See Panel Duct - RH (Remove and Install).