2024-07-23

Glass Run Seal - Front Door - A-Pillar (Remove and Install)

Correction code 1170042051 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH front door closeout panel. See Closeout Panel - Front Door - LH (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the window regulator from the closeout panel.
  2. Remove the bolts (x2) that attach the LH front door glass run seal to the door assembly, and then remove the seal from the door.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front door glass run seal into the door assembly, and then install the bolts (x2) that attach the seal to the door.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH front door closeout panel assembly. See Closeout Panel - Front Door - LH (Remove and Install).