2024-07-23

Rail - Center Floor - LH (Remove and Install)

Correction code 1530083031 1530083032 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully rearward.
  3. Pull the LH center floor rail upwards to release the clips (x4) and datum (x3), and then remove the floor rail from the vehicle.

Install

  1. Position the LH center floor rail into the vehicle, and then press the floor rail downward to secure the clips (x4) and datum (x3).
  2. Restore the LH front seat back to its original position.
  3. Raise the LH front window and close the LH front door.