Undertray - Rear Aeroshield (Remove and Install)
Correction code
1203128041
1203128042
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
-
Remove the bolts (x7) that attach the
rear aeroshield to the vehicle, and then slide the rear aeroshield from under mid
aeroshield to remove it from the vehicle.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
Install
-
Position the rear aeroshield to the vehicle, slide the rear aeroshield under the mid
aeroshield and into position, and then install the bolts (x7) that attach it to the
vehicle.6 Nm (4.4 lbs-ft)NoteApply Loctite 222 to the fasteners before installation.TIpUse of the following tool(s) is recommended:
- 10 mm socket
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Raise the LH front window and close the LH front door.