23/07/2024 17:32:00

Interior Ducting and Vents - Panel Duct - LH (Remove and Install)

Correction code 1405077111 1405077112 1405077121 1405077122 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH side window demist duct. See Interior Ducting and Vents - Side Window Demist Duct - LH (Remove and Install).
  2. Remove the screws (x4) that attach the IP airwave module to the IP assembly.
    2.4 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Release the clips (x2) and disconnect the electrical connector that attach the LH panel duct to the vehicle, and then remove the duct from the vehicle.

Install

  1. Position the LH panel duct to the vehicle, and then secure the clips (x2) and connect the electrical connector that attach the duct to the vehicle.
  2. Install the screws (x4) that attach the IP airwave module to the IP assembly.
    2.4 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Install the LH side window demist duct. See Interior Ducting and Vents - Side Window Demist Duct - LH (Remove and Install).