23/07/2024 17:25:51

Bed Lights - Bed Light - LH (Remove and Install)

Correction code 1740015011 1740015012 1740015021 1740015022 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tonneau cover.
  2. Open the tailgate.
  3. Starting from the rear, release the clips (x8) that attach the LH upper bed side wall assembly to the vehicle, and then remove the side wall from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the tonneau seal as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull from the bottom downwards.
  4. Remove the upper fasteners (x4) on the lower bed side wall.
    11 Nm (8.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Remove the bolts (x3) that attach the LH bed light assembly to the vehicle, disconnect the bed light electrical connector, and then remove the assembly from the vehicle.
    2.5 Nm (1.8 lbs-ft)
    1. Slide the assembly forward until the connector housing touches the edge of the L-track opening and all tabs are released.
    2. Raise the bed light assembly until it touches the top of the L-track rail.
    3. Move the light assembly out of the L-track rail inboard.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use an airbag to help provide extra access to the rear bolt.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH bed light assembly into the vehicle, connect the electrical connector, and then install the fasteners (x3).
    2.5 Nm (1.8 lbs-ft)
    1. Slide the assembly forward until the connector housing touches the edge of the L-track opening and all tabs are engaged.
    2. Lower the bed light assembly until the datums line up to the L-track rail.
    3. Once the datums are in, slide the assembly back to expose the bolt mounts.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use an airbag to help provide extra access to the rear bolt.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the upper fasteners (x4) on the lower bed side wall.
    11 Nm (8.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Position the LH upper bed side wall assembly to the vehicle, and then secure the clips (x8) that attach the side wall to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the tonneau seal as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  4. Close the tailgate.
  5. Close the tonneau cover.