01/08/2024 15:11:53

Truck Bed Exterior Trim - Rear Lamp Closeout Applique - LH (Remove and Install)

Correction code 1220126061 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

2024-08-01: Update sail applique step to full replacement. Add step to remove rear bed closeout.

Warning

This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

Open the tailgate.
Remove the LH sail applique. See Truck Bed Exterior Trim - Sail Applique Assembly - LH (Remove and Replace).
Remove the LH rear bed closeout. See Truck Bed - Rear Bed Closeout - LH (Remove and Install).
Release the clips (x2) that attach the LH lamp closeout applique to the vehicle, and then remove the applique from the vehicle.

Note
Slide the applique out of the tail lamp groove.

Install

Position the LH lamp closeout applique to the vehicle, and then secure the clips (x2) that attach the applique to the vehicle.

Note
Make sure the applique is seated in the tail lamp groove.

Note
Replace any damaged or missing clips.
Install the LH rear bed closeout. See Truck Bed - Rear Bed Closeout - LH (Remove and Install).
Install the LH sail applique. See Truck Bed Exterior Trim - Sail Applique Assembly - LH (Remove and Replace).
Close the tailgate.