2024-07-23
Rear Door Trim Pad - Rear NVH Foam - LH (Remove and Install)
Correction code
1513091101
1513091102
1513091111
1513091112
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Remove the LH rear door beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
- Remove the LH rear door trim. See Rear Door Trim Pad - Door Trim Rear - LH (Remove and Install).
-
Remove the LH rear door trim NVH foam
from the door trim.
NoteLift the NVH foam off of the retaining tabs.
Install
-
Position the LH rear door trim NVH foam onto the door trim, and then secure the NVH
foam to the retaining tabs.
- Install the LH rear door trim. See Rear Door Trim Pad - Door Trim Rear - LH (Remove and Install).
- Install the LH rear door beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).