2026-08-09

Horn - Low Tone - LH (Remove and Install)

Correction code 2121012071 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  2. Remove the bolt that attaches the LH low tone horn assembly to the vehicle, release the connector lock and disconnect the electrical connector, and then remove the horn assembly from the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH low tone horn assembly into the vehicle, connect the electrical connector and secure the connector lock, and then install the bolt that attaches the horn assembly to the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the frunk assembly. See Frunk Assembly (Remove and Install).