2026-08-09

Door Striker - Rear - LH (Remove and Install)

Correction code 1133041061 1133041062 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Apply masking tape to indicate the striker position.
  3. Remove the bolts (x2) that attach the door striker to the vehicle, and then remove the striker from the vehicle.
    24 Nm (17.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T40 socket

Install

  1. Position the door striker to the vehicle, and then install the bolts (x2).
    24 Nm (17.7 lbs-ft)
    Note
    Install the bolts loosely, align the striker to the tape marks, and then tighten the bolts.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  2. Remove the masking tape and clean the area of any residue.
  3. Raise the LH rear window and close the LH rear door.