2024-07-23

Wheel Cover - Front - LH (Remove and Install)

Correction code 34015021 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Use both hands to gently pull the wheel cap away from the wheel to release the clips (x8).
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the mounting ring is removed with the cap.

Install

  1. Partially install the wheel cap to wheel. While the cap is partially installed, rotate the wheel cap to align with the tire design.
  2. Once the wheel is aligned with the tire design, press from the center of the wheel cap into the wheel to engage the clips (x8).