2024-11-26

Mud Flap - Front - LH (Remove and Install)

Correction code 12207301 12207302 12207501 12207502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Turn the steering wheel fully to the left to provide access to the working area.
  3. Remove the clips (x2) that attach the LH front mud flap to the LH front wheel arch liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the clips starting from right to left.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Clip pry tool
    Figure 1. LH shown; RH similar
  4. Remove the bolts (x2) that attach the LH front mud flap to the LH rocker panel, and then remove the mud flap from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 2 in extension
    • 10 mm deep socket
    • Cordless Ratchet/Impact Driver
    Figure 2. LH shown; RH similar
    Figure 3. LH shown; RH similar

Install

  1. Position the LH front mud flap on the vehicle, and then install the bolts (x2) that attach the mud flap to the LH rocker panel.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the bolts with the rocker panel holes.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 2 in extension
    • 10 mm deep socket
    • Cordless Ratchet/Impact Driver
    • Torque wrench with angle measurement
    Figure 4. LH shown; RH similar
    Figure 5. LH shown; RH similar
  2. Install the clips (x2) that attach the LH front mud flap to the LH front wheel arch liner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the clips starting from right to left.
    Figure 6. LH shown; RH similar
  3. Raise the LH front window and close the LH front door.