2026-08-09

Floor Duct - Outboard - LH - Instrument Panel (Remove and Install)

Correction code 1405077051 1405077052 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH quarter glass demist duct. See Demist Duct - Quarter Glass - LH (Remove and Install).
  2. Remove the clips (x2) that attach the LH side window demist duct to the vehicle.
  3. Release the clips (x3) that attach the LH outboard IP floor duct to the vehicle, and then remove the duct from the vehicle.
    Note
    Refer to the images for removal clarification.

Install

  1. Position the LH outboard IP floor duct into the vehicle, and then install the clips (x3) that attach the duct to the vehicle.
    Note
    Ensure duct is seated over the LH instrument panel floor duct inboard correctly to avoid circulation problems.
    Note
    Refer to the images for install clarification.
  2. Install the clips (x2) that attach the LH side window demist duct to the vehicle.
  3. Install the LH quarter glass demist duct. See Demist Duct - Quarter Glass - LH (Remove and Install).