23/07/2024 17:30:06

Front Overhead Console Assembly (Remove and Replace)

Correction code 1505103012 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Install

  1. Install the front overhead console assembly. See Front Overhead Console Assembly (Remove and Install).
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Unlock the vehicle gateway. See Gateway (Unlock).
  4. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  5. In Toolbox, click the Actions/Autodiag tab, and then search for "Update Front Overhead Module".
  6. Click the Update Front Overhead Module routine, click Run, and allow the routine to complete.
  7. Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).
  8. Exit Service Mode. See Service Mode.
  9. Raise the LH front window and close the LH front door.