23/07/2024 17:23:49
A-B-C Post Interior Trim - C-Pillar Lower Trim - LH (Remove and Install)
Correction code 1518006081 1518006082 1518006101 1518006102 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH rear door and lower the LH rear window.
-
Release the clips (x7) that attach the LH lower C-pillar trim to the C-pillar, and
then release the trim from the C-pillar.
NotePull upward from the bottom edge of the trim to release it.NoteThe trim will still be attached to the seatbelt.
-
Remove and discard the bolt that
attaches the seatbelt anchor to the vehicle, and then feed the seatbelt through the
C-pillar trim to remove the trim from the vehicle.Tip: Use of the following tool(s) is recommended:
- 13 mm socket
Install
-
Feed the seatbelt anchor through the LH C-pillar lower trim, and then install a new
bolt that attaches the seatbelt anchor to the vehicle.Tip: Use of the following tool(s) is recommended:
- 13 mm socket
-
Position the LH lower C-pillar trim to the C-pillar, and then secure the clips (x7)
that attach the trim to the C-pillar.
NoteReplace any missing or damaged clips.
- Raise the LH front window and close the LH front door.