2024-07-23
Impact and Acceleration Sensors - Door Pressure Sensor, PPS3E, A Key (Remove and Replace)
Correction code
2020075011
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
- Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
- Disconnect MV power. See Disconnect MV Power (Modify).
- Remove the LH front door beltline assembly. See Front Door Trim Pad - Beltline Assembly - LH (Remove and Install).
- Remove the LH front door trim. See Front Door Trim Pad - Door Trim Front - LH (Remove and Install)
- Disconnect the impact sensor electrical connector, and then turn impact sensor counterclockwise to release it from the door.
Install
- Install the LH front door impact sensor into the LH front door, turn the sensor clockwise to secure it, and then connect the electrical connector.
- Reconnect MV power. See Disconnect MV Power (Modify)
- Install the LH front door trim. See Front Door Trim Pad - Door Trim Front - LH (Remove and Install)
- Place the vehicle into Service Mode. See Service Mode.
-
On the vehicle touchscreen, navigate
to Software Reinstall > Reinstall to reinstall the software.
NoteThe installation will begin immediately.
-
Calibrate the LH front window.
NotePress and hold the selected window switch for 15 seconds. Raise the window and hold for 15 seconds. Test the window by hard pressing to verify the auto raise/lower functions correctly.
- Raise the LH front window and close the LH front door.