06/09/2024 11:14:08

2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install)

Correction code 1305002011 1305002012 1305002021 1305002022 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-09-06: Updated remove and install steps for new bolster version.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Release the clips (x3) and datum, and tabs (x2) that attach the LH 2nd row seat outboard side bolster to the seat assembly, partially release the LH 2nd row shoulder cover, and then remove the bolster from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the bolster from the bottom and work upwards.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fastener count may vary depending on vehicle build.
    Figure 1. Fastener count (5 clips, 2 datums) on previous version

Install

  1. Position the LH 2nd row seat outboard side bolster to the seat assembly, engage the clips (x3), datum, and tabs (x2) that attach the bolster to the seat assembly, and then secure the LH 2nd row shoulder cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test to ensure the fasteners are fully engaged.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fastener count may vary depending on vehicle build.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
    Figure 2. Fastener count (5 clips, 2 datums) on previous version
  2. Raise the LH rear window and close the LH rear door.