23/07/2024 17:32:29

Passenger Ducting and Vents - 2nd Row Duct On Rails (Remove and Install)

Correction code 1810084071 1810084072 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully rearward.
  3. Partially the release LH side lower A-pillar primary seal.
  4. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  5. Remove the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  6. Remove the footwell cover. See Dash Support Frame - Footwell Cover (Remove and Install).
  7. Remove the LH center floor rail. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
  8. Remove the accelerator pedal side trim. See Passenger Compartment Carpet - Pedal - Side Trim (Remove and Install).
  9. Remove the accelerator pedal. See Accelerator Pedal (Remove and Install).
  10. Open the RH front door and lower the RH front window.
  11. Move the RH front seat fully rearward.
  12. Partially release the RH front door seal.
  13. Repeat step 4 through step 7 for the RH side of the vehicle.
  14. Fold back the RH carpet.
  15. Remove the center console front panel. See Center Console - Front Panel Assembly (Remove and Install).
  16. Remove the center floor trim. See Passenger Compartment Carpet - Center Floor Trim (Remove and Install).
  17. Removal the center floor upper bracket. See Passenger Compartment Carpet - Center Floor Upper Bracket (Remove and Install).
  18. Pull the 2nd row duct on rails from the bottom to release it from the vehicle, and then remove the duct from the vehicle.

Install

  1. Install the 2nd row dual duct on rails into the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Maneuver as needed through foam insert.
  2. Install the center floor upper bracket. See Passenger Compartment Carpet - Center Floor Upper Bracket (Remove and Install).
  3. Install the center floor trim. See Passenger Compartment Carpet - Center Floor Trim (Remove and Install).
  4. Install the center console front panel. See Center Console - Front Panel Assembly (Remove and Install).
  5. Unfold the RH front cabin carpet into position.
  6. Install the RH center floor rail. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
  7. Install the RH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  8. Install the RH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  9. Install the RH front door seal.
  10. Unfold the LH front cabin carpet into position.
  11. Install the accelerator pedal. See Accelerator Pedal (Remove and Install).
  12. Install the accelerator pedal side trim. See Passenger Compartment Carpet - Pedal - Side Trim (Remove and Install).
  13. Install the LH center floor rail. See Passenger Compartment Carpet - Center Floor Rail - LH (Remove and Install).
  14. Install the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  15. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  16. Install the LH side lower A-pillar primary seal.
  17. Install the footwell cover. See Dash Support Frame - Footwell Cover (Remove and Install).
  18. Restore the RH front seat back to its original position.
  19. Raise the RH front window and close the RH front door.
  20. Restore the LH front seat back to its original position.
  21. Raise the LH front window and close the LH front door.