2024-10-28

Panel Duct - RH (Remove and Install)

Correction code 1810084181 FRT 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-10-28: Removed redundant links to avoid confusion.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the glovebox assembly. See Glovebox Assembly (Remove and Install).
  2. Release the clips (x2) that attach the RH airwave duct to the vehicle, disconnect the electrical connector, and then remove the duct from the vehicle.

Install

  1. Position the RH airwave duct into the vehicle, connect the electrical connector, and then install the clips (x2) that attach the duct to the vehicle.
  2. Install the glovebox assembly. See Glovebox Assembly (Remove and Install).