23/07/2024 17:26:51

Charge Port - Assembly Charge Port Controller ECU Gen 4 (Remove and Replace)

Correction code 4401024022 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the LH rear door and lower the LH rear window.
  3. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  4. Disconnect MV power. See Disconnect MV Power.
  5. Remove the LH 2nd row seat outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  6. Disconnect the electrical connectors (x3) from the charge port ECU.
  7. Remove the bolt that attaches the charge port ECU to the vehicle, and then remove the ECU from the vehicle.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket

Install

  1. Position the charge port ECU into the vehicle, and then install the bolt that attaches the ECU to the vehicle.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the charge port ECU into the cavity for installation.
    Tip: Use of the following tool(s) is recommended:
    • 8 mm socket
  2. Connect the electrical connectors (x3) to the charge port ECU.
  3. Install the LH 2nd row seat outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  4. Reconnect MV power. See Disconnect MV Power.
  5. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  6. Raise the LH rear window and close the LH rear door.
  7. Connect a laptop with Toolbox to the vehicle. See Toolbox 3 (Connect and Disconnect).
  8. In Toolbox, click the Actions tab, and then search for "Service-Redeploy".
  9. Click SERVICE CAN REDEPLOY, click Run, and allow the routine to complete.
  10. Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).
  11. Raise the LH front window and close the LH front door.