2025-02-14
Door Presenter - Front Door - LH (Remove and Replace)
Correction code
1133041002
FRT
0.42
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components.
Remove
-
Remove the LH front door closeout
panel. See Closeout Panel - Front Door - LH (Remove and Install).
NoteIt is not necessary to remove the window regulator from the closeout panel.
-
Disconnect the closure harness from
the LH door presenter.
-
Remove the bolts (x2) that attach the
LH door presenter to the vehicle, and then remove the door presenter from the
vehicle.
13 Nm (9.6 lbs-ft)TIpUse of the following tool(s) is recommended:- Torx T30 socket
Install
-
Position the LH door presenter into
the vehicle, and then install the bolts (x2) that attach the door presenter to the
vehicle.
13 Nm (9.6 lbs-ft)TIpUse of the following tool(s) is recommended:- Torx T30 socket
-
Connect the closure harness to the LH door presenter.
- Install the LH front door closeout panel assembly. See Closeout Panel - Front Door - LH (Remove and Install).