Radar - Cabin (Remove and Install)
Correction code 1720078011 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
-
Disconnect the interior radar
electrical connector, remove the bolt that attaches the radar to the vehicle, and then
release the clip to remove the radar from the vehicle.NoteRelease the locking tab before disconnecting the connector.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Install
-
Install the interior radar into the vehicle, install the bolt that attaches the radar
to the vehicle, and then connect the electrical connector.NoteEngage the connector lock.Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
- Raise the LH front window and close the LH front door.