2026-08-09

Harness - Fascia - Rear (Remove and Replace)

Correction code 1710095021 1710095022 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear fascia from the vehicle. See Rear Fascia (Remove and Install)
  2. Release the clips (x13) that attach the rear fascia harness to the rear fascia assembly, release the connector locks and disconnect the electrical connectors (x6), and then remove the harness from the assembly.

Install

  1. Position the rear fascia harness into the rear fascia assembly, connect the electrical connectors (x6) and engage the connector locks, and then secure the clips (x13) that attach the harness to the assembly.
  2. Install the rear fascia. See Rear Fascia (Remove and Install)