23/07/2024 17:26:44

Center Console - Console, Airwave, Airwave Cap (Remove and Install)

Correction code 1519023051 1519023052 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open all the doors and lower all the windows.
  2. Move the LH and RH front seats fully forward.
  3. Remove the center console armrest cap. See Center Console - Armrest Cap Assembly (Remove and Install).
  4. Remove the top decor. See Center Console - Top Decor Assembly (Remove and Install).
  5. Release the clips (x5) that attach the LH side of the center console external panel to the center console assembly.
  6. Gently pull the LH external panel outward until there is sufficient access to the screws that attach the LH side of the airwave cap to the center console assembly, and then remove the screws (x2) that attach the LH side of the airwave cap to the center console assembly.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  7. Repeat steps 5 and 6 for the RH side of the center console.
  8. Pull the airwave cap downward to release the lower clips (x2), and then remove the airwave cap from the vehicle.

Install

  1. Position the airwave cap into the vehicle, and then push the airwave cap upward to engage the lower clips (x2) that attach the airwave cap to the vehicle.
  2. Gently pull the LH external panel outward until there is sufficient access to the screws that attach the LH side of the airwave cap to the center console assembly, and then install the screws (x2) that attach the LH side of the airwave cap to the center console assembly.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Engage the clips (x5) that attach the LH side of the center console external panel to the center console assembly.
  4. Repeat steps 2 and 3 for the RH side of the center console.
  5. Install the top decor. See Center Console - Top Decor Assembly (Remove and Install).
  6. Install the center console armrest cap. See Center Console - Armrest Cap Assembly (Remove and Install).
  7. Restore the LH and RH front seats back to their original position.
  8. Raise all the windows and close all the doors.