23/07/2024 17:29:23

Front Door Trim Pad - Puddle Lamp V2.0 (Remove and Install)

Correction code 1513047021 1513047022 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Release the LH front puddle lamp from the LH front door trim, disconnect the electrical connector, and then remove the puddle lamp from the vehicle.

Install

  1. Position the LH front puddle lamp to the LH front door trim, connect the electrical connector, and then secure the puddle lamp to the door trim.
  2. Raise the LH front window and close the LH front door.