2024-07-23

Exterior Mirror Glass - Flat - Electrochromic Dimming - LH (Remove and Install)

Correction code 1209034071 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Push the LH exterior mirror glass fully outboard, then upward, and then pull the glass from the inboard lower corner to release it from the mirror assembly.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not release the mirror too far from the mirror assembly as the harness is still connected.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure the harness is not strained.
  2. Disconnect the electrical connectors (x3), and then remove the LH exterior mirror from the mirror assembly.

Install

  1. Position the LH exterior mirror glass to the mirror assembly, connect the electrical connectors (x3), and then apply pressure from the center to secure the glass to the mirror assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Engagement will be audible.
    Informational PurposesAn informational icon, calling your attention
    Note
    Gently pull the glass to make sure it is secure.