2024-07-23

Seal - Frunk (Remove and Install)

Correction code 1224057011 1224057012 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the powered frunk.
  2. Remove the frunk seal.

Install

  1. Position the funk seal into the vehicle, and then press the seal into the groove.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the seal is fully seated.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Gentle strikes with a dead blow hammer can aid in seating the seal.
  2. Close the powered frunk.