23/07/2024 17:33:22

Rear Energry Absorber - Center Bracket (Remove and Install)

Correction code 1001094011 1001094012 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).
  2. Remove the LH rear center step bracket. See Rear Bumper Fascia - Fascia Step Bracket Center - LH (Remove and Install).
  3. Remove the LH rear body side bracket. See Rear Bumper Fascia - Body Side Bracket - LH (Remove and Install).
  4. Repeat steps 2 and 3 for the RH side of the vehicle.
  5. Remove the nuts (x2) that attach the center bracket to the vehicle, and then remove the center bracket from the vehicle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the center bracket into the vehicle, and then install the nuts (x2) that attach the center bracket to the vehicle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the RH rear body side bracket. See Rear Bumper Fascia - Body Side Bracket - LH (Remove and Install).
  3. Install the RH rear center step bracket. See Rear Bumper Fascia - Fascia Step Bracket Center - LH (Remove and Install).
  4. Repeat steps 2 and 3 for the LH side of the vehicle.
  5. Install the rear fascia assembly. See Rear Bumper Fascia - Rear Fascia (Remove and Install).