23/07/2024 17:34:13

Steering Column and Wheel - Shroud Lower Clip Instrument Panel - Steering Column (Remove and Install)

Correction code 3205111011 3205111012 FRT 0.71 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  3. Disconnect MV power. See Disconnect MV Power.
  4. Remove the driver airbag. See Front Air Bags - Driver Airbag Assembly (Remove and Install).
  5. Remove the steering wheel. See Steering Column and Wheel - Steering Wheel Pur Heated (Remove and Install).
  6. Remove the steering column shroud lower instrument panel. See Steering Column and Wheel - Shroud Lower Instrument Panel - Steering Column (Remove and Install)
  7. Release the tabs (x2) that attach the steering column shroud lower clip to the steering column shroud, and then remove the clip from the vehicle.

Install

  1. Install the lower clip into the steering column shroud.
  2. Install the steering column shroud lower instrument panel. See Steering Column and Wheel - Shroud Lower Instrument Panel - Steering Column (Remove and Install)
  3. Install the steering wheel. See Steering Column and Wheel - Steering Wheel Pur Heated (Remove and Install).
  4. Install the driver airbag. See Front Air Bags - Driver Airbag Assembly (Remove and Install).
  5. Reconnect MV power. See Disconnect MV Power.
  6. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  7. Raise the LH front window and close the LH front door.