2026-08-09

Accelerator Pedal (Remove and Install)

Correction code 3325020021 3325020022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-06-27: Updated torque value for pedal fasteners.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully rearward.
  3. Remove the accelerator pedal side trim. See Side Trim - Pedal (Remove and Install).
  4. Fold back the LH front cabin carpet.
  5. Remove the fasteners (x2) that attach the accelerator pedal to the vehicle, release the connector lock and disconnect the electrical connector, and then feed the extension harness through the carpet to remove the pedal from the vehicle.
    Note
    Fastener and connector location may vary depending on build.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
    Figure 1. Fastener and connector variation

Install

  1. Position the accelerator pedal into the vehicle, feed the extension harness through the carpet, connect the electrical connector and engage the connector lock, and then install the fasteners (x2) that attach the pedal to the vehicle.
    10 Nm (7.4 lbs-ft)
    Note
    Fastener and connector location may vary depending on build.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
    Figure 2. Bolt and connector variation
  2. Unfold the LH front cabin carpet into position.
  3. Install the accelerator pedal side trim. See Side Trim - Pedal (Remove and Install).
  4. Restore the LH front seat back to its original position.
  5. Raise the LH front window and close the LH front door.