2026-02-02

Blower - Cushion - Front Seat - LH (Remove and Replace)

Correction code 1301010312 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-02-02: Released new procedure.

Remove

  1. Open the LH front door.
  2. Raise the LH front seat to maximum height.
  3. Disconnect cushion blower electrical connector.
  4. Release the clips (x2) that attach the cushion blower to the seat assembly, and then remove the blower from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the clips in, pull the blower downward, then slide the blower forward.

Install

  1. Position the cushion blower into the seat assembly, and then engage the clips (x2) that attach the blower to the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Insert alignment tab, and then push upwards to engage the clips.
  2. Connect the cushion blower electrical connector.
  3. Restore the LH front seat back to its original position.
  4. Close the LH front door.