2026-08-09

Impact Sensor - Front End Module - RH (Remove and Install)

Correction code 2020075021 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Enable Service Mode via the vehicle touchscreen. See Service Mode.
  3. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  5. Release the connector lock and disconnect the electrical connector, remove the bolt that attaches the RH front end module impact sensor to the vehicle, and then remove the sensor from the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the RH front end module impact sensor into the vehicle, connect the electrical connector and engage the locking tab, and then install the bolt that attaches the sensor to the vehicle.
    10 Nm (7.4 lbs-ft)
    Note
    Align the locating tab.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Exit Service Mode. See Service Mode.
  5. Raise the LH front window and close the LH front door.