23/10/2024 10:41:44
USB Hub - VCUSB (Remove and Replace)
Correction code
1519129012
FRT
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-10-23: Replaced Toolbox 3 direction with firmware reinstallation via UI.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Remove the VCUSB. See USB Hub - VCUSB (Remove and Install).
Install
- Install the VCUSB. See USB Hub - VCUSB (Remove and Install).
- Reinstall the vehicle software. See Software Reinstall - Touchscreen.
- Restore the LH front seat back to its original position.
- Raise the LH front window and close the LH front door.