2026-08-09

Button - Cushion Adjust - 1st Row Seat - RH (Remove and Install)

Correction code 1301059041 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the RH front door and lower the RH front window.
  2. Move the RH front seat fully forward.
  3. Use a flathead screwdriver to rotate the lock mechanism on the front seat belt linkage counterclockwise to release it from the pretensioner, and then slide the linkage off the pretensioner and set it aside.
    CAUTION
    DO NOT rotate clockwise to avoid damage to the mechanism.
    Note
    The linkage design may vary, but will function the same.
    Note
    The lock screw will remain in the horizontal position when released.
    Note
    A light audible click will be heard when the linkage is released.
  4. Remove the cushion and recliner adjustment buttons. See
  5. Remove the RH outboard side shield. See Side Shield - Outboard - 1st Row Seat - LH (Remove and Install).
  6. Remove the bolts (x3), and then remove the 1st row seat switch assembly.
    0.8 Nm (7 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Install the bolts (x3) that attach the 1st row seat switch assembly.
    0.8 Nm (7 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Install the RH outboard side shield. See Side Shield - Outboard - 1st Row Seat - LH (Remove and Install).
  3. Install the cushion and recliner adjustment buttons. See
  4. Install the front seat belt linkage to the pretensioner:
    1. Make sure the lock screw is in the horizontal position. If the lock screw is not in the horizontal position, follow the release instructions to unlock it.
    2. Verify there are no twists in the seat belt from the upper B-pillar trim to the pretensioner.
    3. Install the linkage onto the pretensioner cable.
      Note
      An audible click will be heard.
      Note
      The lock screw will rotate back to the locked position.
    4. Perform a firm pull test on the seat belt with at least 15 pounds of force.
  5. Restore the RH front seat back to its original position.
  6. Raise the RH front window and close the RH front door.