23/07/2024 17:35:42

USB Hub - Back Panel Solo USB Hub (Remove and Install)

Correction code 1519129021 1519129022 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully forward.
  3. Open the LH rear door and lower the LH rear window.
  4. Release the clips (x10) that attach the center console rear panel to the center console assembly.
  5. Remove the screws (x2) that attach the LH 2nd row USB hub to the center console rear panel, disconnect USB hub electrical connector, and then remove the USB hub from the vehicle.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the LH 2nd row USB hub onto the center console rear panel, connect USB hub electrical connector, and then install the screws (x2) that attach the USB hub to the panel.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Secure the clips (x10) that attach the center console rear panel to the center console assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  3. Raise the LH rear window and close the LH rear door.
  4. Restore the LH front seat back to its original position.
  5. Raise the LH front window and close the LH front door.