2026-08-09

Aeroshield - Control Arm - Lower - Rear - LH (Remove and Install)

Correction code 3103101051 3103101052 3103101061 3103101062 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Press the brake pedal to turn on drive rails.
  3. Set the air suspension ride height to “Very High”.
    Note
    On the vehicle touchscreen, navigate to > Controls > Suspension > Off Road > Very High.
  4. Remove the bolts (x3) that attach the LH rear lower control arm aeroshield to the vehicle, and then remove the aeroshield from the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH rear lower control arm aeroshield to the vehicle, and then install the bolts (x3) that attach the aeroshield to the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Press the brake pedal to turn on drive rails.
  3. Set the air suspension ride height to “Medium”.
    Note
    On the vehicle touchscreen, navigate to > Controls > Suspension > Medium.
  4. Raise the LH front window and close the LH front door.