16/01/2025 14:55:16

Truck Bed Exterior Trim - Sail Applique Assembly - RH (Remove and Replace)

Correction code 1220126022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2025-01-16: Updated install section to point to sail applique retrofit.
  • 2024-12-02: Added steps to remove/install tonneau applique.
  • 2024-06-25: Revised installation steps for push nut.
  • 2024-06-25: Added note to discard the applique after removal.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the tonneau applique. See Tonneau Applique (Remove and Install).
  3. Release the clips (x9) and double side tape strips (x6) that attach the RH sail applique to the vehicle, and then remove the RH sail applique from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Discard the sail applique after removal. Do not reuse any of the fasteners.
  4. Thoroughly clean the bed side area of any remaining residue.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining double sided tape.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a cordless drill with an eraser wheel attachment to clean residue that is difficult to remove.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use IPA wipes to remove any remaining adhesive.

Install

If the vehicle was equipped with sail appliques with PN: 1741538-XX-X (LH) and 1741539-XX-X (RH), retrofit the sail appliques with updated parts. Refer to the Service Manual procedure Truck Bed Exterior Trim - Sail Applique Set (Retrofit).

If the vehicle is equipped with the updated sail applqiues (PN: 2009390-00-A (LH), PN: 2009391-00-A (RH)), refer Service Manual procedure Truck Bed Exterior Trim - Sail Applique Assembly - LH (Remove and Install) (Post 11/4/2024) or Truck Bed Exterior Trim - Sail Applique Assembly - RH (Remove and Install) (Post 11/4/2024).