23/07/2024 17:28:11

Exterior Trim Fittings - Backlite Applique Assembly - LH (Remove and Install)

Correction code 1220035131 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Press the forward arrow on the LH bed rail to open the tonneau cover.
  2. Open the tailgate.
  3. Release the clips (x2) that attach the LH backlight applique to the vehicle, and then remove the applique from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pry the applique inward to release it.

Install

  1. Position the LH backlight applique into the vehicle, and then secure the clips (x2) that attach the applique to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  2. Close the tailgate.
  3. Close the tonneau cover.