2026-08-09

Bed Tiedown Assembly - Fore - LH (Remove and Install)

Correction code NA NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Remove the LH bed side wall. See Bed Side Wall - LH (Remove and Install).
  4. Remove the nut that attaches the LH fore bed tiedown assembly to the vehicle, and then remove the tiedown from the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH fore bed tiedown assembly to the vehicle, and then install the nut that attaches the tiedown to the vehicle.
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH bed side wall. See Bed Side Wall - LH (Remove and Install).
  3. Exit Service Mode. See Service Mode.
  4. Raise the LH front window and close the LH front door.