19/12/2024 16:41:32

Wheel Cover - Front - LH (Remove and Replace)

Correction code 34015022 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-12-19: Added additional tips and photos. Recommend using hands to separate mounting ring and wheel cover.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Use both hands to firmly pull the wheel cover away from the wheel to release the clips (x8).
    Informational PurposesAn informational icon, calling your attention
    Note
    The cover may release with or without the mounting ring attached.
  2. If the mounting ring is still attached to the wheel, pull the ring away from the wheel to release the clips (x7). If the mounting ring released from the wheel with the cover, skip this step.
    Informational PurposesAn informational icon, calling your attention
    TIp
    For more leverage, pull on the outermost ring.

Install

  1. With one hand on the mounting ring and the other hand on the wheel cover, pull the ring and cover apart to release the clips (x7) that attach the ring to the cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Hold the mounting ring between clips. Do not hold the ring directly on top of a clip.
  2. Position the mounting ring onto the wheel, and then press the mounting ring into the wheel to engage the clips (x7).
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure all the clips are fully engaged with the wheel spokes.
    Informational PurposesAn informational icon, calling your attention
    TIp
    The mounting ring clips are installed between the wheel spokes.
  3. Position the wheel cover onto the mounting ring, but do not engage the wheel cover clips yet. Rotate the wheel cover so that the rubber flaps align with the markings on the tire. When aligned, press the cover inward from the center of the cover, making sure all the clips (x8) are fully engaged.