Cushion Assembly - 2nd Row Seat - RH (Remove and Replace)
Correction code
1305002071
1305002072
FRT
0.71
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the RH 2nd row seat underbelly. See Underbelly - 2nd Row Seat - RH (Remove and Install).
- Release the connector bracket from the seat frame, and then disconnect the 2nd row seat cushion electrical connectors (x2) and release the clips (x4).
-
Remove the clips (x4) that attach the
RH 2nd row seat cushion assembly to the vehicle, and then slide the cushion assembly
upwards to remove it from the seat frame.
NotePull the seat cushion trim back to access the side clips.
Install
-
Position the RH 2nd row seat cushion assembly to the vehicle, slide the cushion
assembly downward and onto the seat frame, and then install the clips (x4)..
NotePull the seat cushion trim back to access the side clips.
- Connect the 2nd row seat cushion electrical connectors (x2) and secure the clips (x4), and then secure the bracket to the seat frame.
- Install the RH 2nd row seat underbelly. See Underbelly - 2nd Row Seat - RH (Remove and Install).