Ambient Light - Map Pocket - Door Panel - Rear - LH (Remove and Install)
Correction code
1513091011
1513091012
FRT
Ambient Light - Map Pocket - Door Panel - Rear - LH (Remove and Install)
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH rear door and lower the LH rear window.
- Remove the LH rear beltline assembly. See Beltline Assembly - Door Panel - Rear - LH (Remove and Install).
- Remove the LH rear door trim. See Panel - Door Trim - Rear - LH (Remove and Install).
-
Remove the LH rear door trim NVH foam
from the door trim.
NoteLift the NVH foam off of the retaining tabs (x3).
-
Disconnect the LH rear door map pocket
lamp electrical connector, release the connector housing from the door trim, and then
remove the lamp from the door trim.
NoteGently pull the map lamp to release it from the cavity.
Install
-
Position the LH rear door map pocket
lamp into the door trim, connect the electrical connector, and then push the map lamp
into position to secure it.
NoteMake sure the harness is routed correctly.
- Position the LH rear door trim NVH foam onto the door trim, and then secure the foam onto the retaining tabs (x3).
- Install the LH rear door trim. See Panel - Door Trim - Rear - LH (Remove and Install).
- Install the LH rear beltline assembly. See Beltline Assembly - Door Panel - Rear - LH (Remove and Install).
- Raise the LH front window and close the LH front door.