2024-07-23

Sun Visor - LH (Remove and Install)

Correction code 1505113031 1505113032 1505113041 1505113042 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the front header trim. See Trim - Header - Front (Remove and Install).
  3. Remove the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  4. Remove the LH IP quarter panel. See Quarter Panel Assembly - LH - Instrument Panel (Remove and Replace).
  5. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  6. Remove the LH A-pillar forward trim. See Trim - A-Pillar - Forward - LH (Remove and Install)
  7. Disconnect the LH sun visor electrical connector, remove the bolts (x2) that attach the visor to the vehicle, and then remove the visor from the vehicle.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH sun visor into the vehicle, install the bolts (x2) that attach the visor to the vehicle, and then connect the electrical connector.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH A-pillar forward trim. See Trim - A-Pillar - Forward - LH (Remove and Install)
  3. Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  4. Install the LH IP quarter panel. See Quarter Panel Assembly - LH - Instrument Panel (Remove and Replace).
  5. Install the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  6. Install the front header trim. See Trim - Header - Front (Remove and Install).
  7. Raise the LH front window and close the LH front door.