2024-07-23

Bed Side Wall Assembly - Upper - LH (Remove and Install)

Correction code 1220126041 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the tonneau cover.
  2. Open the tailgate.
  3. Starting from the rear, release the clips (x8) that attach the LH upper bed side wall assembly to the vehicle, and then remove the side wall from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the tonneau seal as needed.

Install

  1. Position the LH upper bed side wall assembly to the vehicle, and then secure the clips (x8) that attach the side wall to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the tonneau seal as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any missing or damaged clips.
  2. Close the tailgate.
  3. Close the tonneau cover.