2026-08-09

Controller - USB - Center Console (Remove and Install)

Correction code 1519129011 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the center console front panel assembly. See Panel - Front - Center Console (Remove and Install).
  2. Disconnect the electrical connectors (x2) from the VCUSB.
  3. Remove the screws (x4) that attach the VCUSB to the center console, and then remove it from the vehicle.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the VCUSB into the center console, and then install the screws (x4).
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Connect the electrical connectors (x2).
  3. Install the center console front panel assembly. See Panel - Front - Center Console (Remove and Install).